Make sure that the vehicle's wheel brace has the same hex head size as the nuts or bolts you are selling so in the event of a puncture the wheel brace will fit the nuts or bolts and allow the wheel to be removed.

 

Tighten all nuts and bolts to car manufacturer's recommended torque setting. This information can be found in the vehicles handbook.

 

Do not over tighten. Do not use an air gun. Always apply the handbrake at all times when working on a vehicle.

 

Check the tightness of all nuts or bolts after the first 100 miles and periodically check tightness of all nuts or bolts. Basic safety regulations and common sense should be used.

 

All weights, sizes and measurements stated are approximate. After fitting any of our wheel parts and Accessories, we strongly recommend that before the vehicle is movedor driven, each wheel that has been worked on should be turned through 2 or 3 complete revolutions. Thisis to ensure that no parts foul or obstruct the brakes, suspension or interfere with the smooth turning of the wheel. We also recommend that the wheels are turning to full lock both left and right to ensure they are not fouled.